FLOOD BARRIER H150
Prod. No. H150
Sea-water-resistent 5,0 mm marine-grade aluminum, EN-AW-5754 H22.
2168 x 755 mm. Plus a 120 mm lip on one short side and one long side.
Barrier section 24.9 kg (Support leg 5.6 kg + Foot beam 5.6 kg)
Inero’s patented flood barrier designed to withstand water levels up to 150 cm. A sturdy, durable barrier with quick connectors for easy, time-saving installation.
INERO™ flood barrier segments and support legs are made of sea-water-resistant marine-grade aluminium. The material has high durability and withstands extremely tough outdoor conditions. The sections are erected using a sturdy aluminium support leg with a foot beam. The sections interlock using a patented quick connector to form a continuous, flexible barrier that adapts to the substrate. INERO™ flood barriers are suitable for all common substrates, such as grass, gravel and asphalt. They can also be curved through the use of corner sections – outer and inner corners of 30°. The barriers stop and withstand both standing and rushing water and can be assembled directly in the water as long as the water level is no more than 30 cm.
ASSEMBLES IN THREE EASY STEPS
INERO™ flood barriers are easy to assemble, with no previous knowledge. Six people can install 100 metres of barrier in about an hour.
Connect the barrier sections with the quick connector. It is easiest to do so from left to right.
Mount the support legs and the foot beams. The two galvanized (M16) screws and pre-mounted nuts fit into keyhole slots on the long side of the barrier. Adjust by using a ring spanner 24 mm.
Roll the specially designed polyethylene film over the barrier framework, attach with clips on the top edge, anchor at the bottom with sand or gravel.
Lightweight materials and innovative design contribute to a low weight and good stackability, which simplifies storage and transport. One cargo pallet, specially designed in galvanized steel, holds 25 metres of barrier (barrier sections, support legs, foot beams and membrane). Measures steel crate: 2300 mm x 1000 mm x 1000 mm. Weight: approx. 1300 kg. A cargo container can hold 300 metres.
After use, the barriers can simply be cleaned and reloaded onto the pallets.
INERO™ flood barriers are designed with minimal materials. Their low weight also means reduced carbon emissions from transport. The barriers have an extremely long service life and are 100% recyclable. Sort the bolts and screws as steel. The polyethylene film is single-use only and is suitable for eco-friendly incineration.